Sunday, January 27, 2013

WIP: MG FAZZ part 3

Removing seamlines on big rifle/ big cannon can be so tired and tedious, old MG got this problem, the parts are mostly center-spread. Even a cylinder canister is cut by half, over sand on one part will make the part out of shape.

I took the easier way to cover the seams especially on the details of the cannon, some place are hard to sand and i had to cover it with something. These kotobukiya details part really come in handy.

DSC06203 300x225

 

These part is really hard to sand evenly and to save my time and effort i just cover it with koto parts.kotopart2 225x300

kotopart3 225x300

I had over sand the side of the circular details, might as well just trimmed it off and replace koto parts.

kotopart 225x300

 

Next update will be painting of the MG FAZZ cannon. Stay tuned….


WIP: MG FAZZ part 3

WIP: MG FAZZ part 2

Work on the reinforced armor of MG FAZZ, removing mold lines with ceramic knife, work like magic and it leave very smooth surfaces. Here’s the comparison of the mold lines before and after removal.

DSC06194 300x225

Digital camouflage pattern on the fortified armor, cut the masking tapes into small square and rectangular shapes and mask the blue color. Stressful and time consuming parts.

IMAG0422 225x300

Really glad it turn out well, the hard works do pay off. Now the the fortified armor is done, time to move on to the weapon and back pack. Pheeww….

digital camou 300x223

digital camouflage


WIP: MG FAZZ part 2

WIP: MG FAZZ part 1

It will be a OOB commission build. Spend 2 days snap-fitting this babe.

IMAG0395 225x300

MG FAZZ, with its super big gun and fortified armor really look bad-ass and huge. I love the white armor pair with the grey, will remain this color scheme with little bit of custom.

Going to add in LED for the eye as requested by the client, so here’s some tools i used for the add-on. IMAG0399 225x300

CR1220 battery, battery holder, swtich and red LED.

eye 300x225

I sliced the LED so the tip is flat and glue it on the transparent parts. Testing the LED lit up the clear parts. It look bright and nice.

IMAG0409 225x300

Made some adjustment on the neck parts, as the LED had taken a part in the helmet, had to cut off the neck to make it shorter. Putty up some gaps and will add in details later.

IMAG0407 222x300

The outcome of the modification. The battery and switch is located at the back, and i had build a battery box to conceal the wiring and battery holder.  Next would be remove seamlines and parts separation for painting. Stay tuned.

 


WIP: MG FAZZ part 1
Related Posts Plugin for WordPress, Blogger...